Re: [linrad] Svgalib 1.4.3 to 1.9.18

[Stan <stan@xxxxxxxxxxxxxxx]

Hello Stan

When I tried svgalib 1.4.3 I got lots of error messages I could not (did 
not know how to) correct.
I am running a Intel D865PERL mother board with 1G RAM, 2.4G HT cpu, 80G 
pata hard drive
and SUSe 9.0 pro.   SUSE 9.0 does not support the sata hard drives 
without a patch.
I use an old Matrox Millenium pci video card, 2M ram, no 3D.

I found svgalib-1.9.18 at        http://www.svgalib.org       the 
website suggested by Leif,

downloaded, and processed the same as the original version.

Since you have version 1.4.3 already working, you may have to remove it 
then restart with the latest version.

See    man make    for the manual instructions to the make command, 
possibly   make clean   .....

svgalib-1.9.18 processed without errors or failure messages. Nasm was 
already in the SUSE 9.0 distribution.
linrad-01.17 was started ok but now I continue to fight the sound cards.

The alsa drivers come with the SUSE 9.0 distribution, so for now I will 
stick with them.
alsaconf   shows a successful configuration of the delta 44 pci card and 
a SB 5880 pci soundblaster card.
Under alsaconf  I can get the test .wav file through both cards as an 
output to speakers. So I am missing a fine detail.
In LINRAD and  "I"  for the sound card test,  I can not see any of my 
injected signals on the time domain display.
I am using a 1000 Hz tone from my sinad meter.

The ALSA organization   offers a later version of the sound drivers, 
than I have with the SUSE 9.0 distribution.

Stan, WA1ECF   Cape Cod, MA   FN41sr





Stanka1ze@xxxxxxx wrote:

> Hello Leif,
>
>  
> I have a PentiumIV 2.7Ghz running Linrad-01.18 and svgalib-1.4.3 with 
> VESA driver on a Redhat 8.0 operating system. I would like to change 
> to svgalib-1.9.18. Could you please list the steps you did to get 
> 1.9.18 working. 
>  
> Thank you Stan, KA1ZE 



LINRADDARNIL