[Linrad] Re: WSE / Delta44 / Linad / MAP65 Windows local host setup

[Joe Taylor <Princeton.EDU; joe@xxxxxxxxxxxxxxxx>]

Hi Randy,

> I was sending "CQ WI7P DN40" on another computer into a FT726 with
> dummy load.
> 
> I can see/hear the tones on Linrad and see them on MAP65 but it is not
> decoding them.

Yes, it seems that you are very close.

1. Your screen shot shows the signal level going into MAP65 
is rather too high, +20 dB.  The main spectrum on the Linrad 
screen also shows the noise baseline around +45 dB, higher 
than desirable.  It seems that you should reduce the noise 
level by about 20 dB.

2. Be sure to check the clocks on the computer running 
Linrad+MAP65 and the computer on which you were sending a 
test message into a dummy load.  The clocks should agree to 
within a second or so.

	-- 73, Joe, K1JT

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en
-~----------~----~----~----~------~----~------~--~---


LINRADDARNIL