[Linrad] MAP65iq on Vista

[Edward Cole <acsalaska.net; kl7uw@xxxxxxxxxxxxxxxx>]

I have MAP65iq_r11116 installed and running on a Dell laptop running Vista
Not really knowing what I am doing I plugged in my SDR-IQ and the 
computer asked for a driver.  I let it search for one and it found 
and installed a driver and when I start Linrad in SSB and MAP65 I get 
what looks like a normal waterfall.
I ran the sample file 0759 and it produced a decode and listed 
messages (though not with correct freq or DF) and the bandmap as 
shown in the quick start introduction page.

I will have to try it with the 144/28 xvtr and when the Moon is up, 
next, to be sure all is working (but looks promising).
NOTE:  I am NOT QRV at this time as I am working 100% on getting 
outside cable and antenna work done before first snow's fall - but 
running out of time ;-)
1296 is working in Tx with 60w output; will test LNA on dish next 
clear wx day on sun.
If all is ready, I may be QRV for a limited time during Nov. 7-8th.

73, Ed - KL7UW, WD2XSH/45
======================================
  BP40IQ   500 KHz - 10-GHz   www.kl7uw.com
500-KHz/CW, 144-MHz EME, 1296-MHz EME
DUBUS Magazine USA Rep dubususa@xxxxxxxxxxx
====================================== 


--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en
-~----------~----~----~----~------~----~------~--~---


LINRADDARNIL